With the development of society, laminating machine has been widely used, a good laminating machine not only requires standardized operation, maintenance is equally important, only we develop good use and maintenance habits, in order to extend the life of the machine , For the enterprise to bring greater benefits.
The following describes the maintenance of laminating machine knowledge.
First, the paper section:
1, vacuum pump maintenance: vacuum pump and the partition between the wall, the space at least not less than 10 cm to ensure that the cooling required air flow unimpeded, the ambient temperature does not exceed 45 ℃.
Do not allow the interface to contaminate fluids, grease, water and other contaminants to keep the connections smooth.
When the vacuum pump is running, add butter (60 to 100: 5g and 140: 7g) to lubricate the rolls and the butter mouth, after 5000 hours, replace only the original rolling culture.
2, lifting motor reducer maintenance: the first use of 100 hours after the oil for maintenance, after 2500 / hour oil maintenance once, the oil specifications for the 150 gear oil.
Second, the host part:
1, tanker reducer maintenance: the first use of 100 hours after the oil for maintenance, after 2500 / hour oil change maintenance time, the oil specifications for the 150 gear oil.
2, roller maintenance: each time after the use of the rubber roller to wash, dry, to ensure that no foreign body and glue roller. Such as long-term do not have to clean up dry and moisture-proof packaging, so as to avoid mildew.
3, mirror roller bearing seat maintenance:
4, bonded plastic tire bearing maintenance: add butter once a week.
5, dry roller bearing seat maintenance: add butter once a week.
6, the maintenance of the hydraulic pump: the first 10 hours after the proposed replacement of hydraulic oil.
Oil specifications for the Great Wall 46 # anti-wear hydraulic oil, and then, at least once a year for hydraulic oil, and change the filter every time in the oil. Replace the hydraulic oil before the system should be empty all the hydraulic oil. The optimum working temperature of the hydraulic oil is 30 ° C to 60 ° C. Exceeding the above temperature will affect the service life of the hydraulic oil.
Hydraulic oil should be filled with unused clean hydraulic oil, is strictly prohibited to produce different manufacturers or different types of hydraulic oil mixed use, in order to avoid the production of acid residue and precipitation leaving the hydraulic station can not work properly.
7, mirror roller maintenance: three months plus a thermal oil; Model: 320 # heat transfer oil.
8, pneumatic diaphragm pump (glue pump): every time you get off work, please wash with water, until the pump is completely clean water, remember that this must be done, otherwise it will be blocked due to glue damage the pump.
Third, the machine part:
Reducer maintenance: the first use of 100 hours after the oil for maintenance, after 2500 / hour oil change maintenance time, the oil specifications for the 150 gear oil.